Page History

Table of contents

General instructions

...

...

CPLD Access  

Set B2B Pin JM1-89 (JTAGEN) to VDD (3.3V)

...

1. Connect MiniUSB cable to XMOD
2. Set DIP Switch S1-2 to ON OFF position, see TE0706 TRM#4-bitDIP-switch
3. Power ON the board
4. Run "Lattice Diamond Programmer"

5. Select "Create new project from JTAG chain" and press "OK"

Available CPLD Firmware

• TE0820 CPLD - Firmware description with different Variants for PCB REV03 and newer
  • QSPI / SD /JTAG /eMMC Boot Modi - Default delivered, QSPI or SD Boot Mode is selectable via Boot Mode Pin and carrier depended PGOOD Pin can be used to select JTAG or eMMC Boot
  • QSPI / JTAG Boot Modi - Use QSPI  or JTAG Boot Mode is selectable via Boot Mode Pin
  • JTAG / SD Boot Modi - SD or JTAG Boot Mode is selectable via Boot Mode Pin 
  • QSPI / SD Boot Modi, QSPI or SD Boot Mode is selectable via Boot Mode Pin
• TE0820-REV01_REV02 CPLD - Firmware description with different Variants
  • QSPI / SD Boot Modi - Coming Soon Default delivered, QSPI or SD Boot Mode is selectable (Special FSBL for QSPI Programming with Boot Mode /= JTAG will be provided for Vivado 2017.4 Reference Design and newer).
  • QSPI / JTAG Boot Modi - Default delivered Firmware to be compatible with 7 Series 4x5 CarrierUse QSPI  or JTAG Boot Mode is selectable
  • JTAG / SD Boot Modi - To use SD Boot instead of QSPI to be compatible with 7 Series 4x5 CarrierSD or JTAG Boot Mode is selectable 
  • JTAG / QSPI / SD Boot Modi - In planning and currently not available: Use QSPI, SD or JTAG Boot Mode is selectable (CPLD Pin 23 (NOSEQ) is used as second Boot Mode pin to select JTAG Boot Mode). Attention: This need 7 Series 4x5 Carrier CPLD Firmware update.

Download

• TE0820/<PCB Revision>/Firmware/
  • Use files from the subfolders of your PCB revision

General instructions