Page History
...
- Supported by Intel Quartus (JTAG Mode only)
- Intel JTAG compatible
- Additional UART channel available
- Designed as Surface-mount module
- Based on FTDI FT2232H USB2 Interface
- Designed as Surface-mount module
- RED LED (JTAG activity)
- Additional UART channel available
- Activity LEDsGREEN LED (UART activity)
Block Diagram
Figure 1: TEI0005-01 Block Diagram.
...
| Pin Designator | Signal | Module Direction |
|---|---|---|
| J1 | reserved for future use | out |
| J2 | OEN (enable data transmitting), low active | in |
| J3 | not connected | - |
| J4 | reserved for future use | out |
| J5 | UART RX | in |
| J6 | UART TX | out |
| J7 | not connected | - |
| J8 | not connected | - |
| J9 | not connected | - |
| J10 | not connected | - |
| J11 | not connected | - |
| J12 | not connected | - |
| ...J13 | not connected | - |
| J14 | USB-VBUS (USB Host supply voltage) | in |
| J15 | USB Data - | bidir |
| J16 | USB Data + | |
| J17 | GND | - |
| J18 | 3.3V output voltage from module | out |
| J19 | TCK | out |
| J20 | GND | - |
| J21 | TDI | out |
| 2J2 | TMS | out |
| 2J3 | VREF (Reference I/O-voltage from target board for JTAG and UART) | in |
| J24 | TDO | in |
...
Overview
Content Tools