Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Please use Master Pin-out Table table as primary reference for the pin mapping information.

Info

J5 and J6 are incompatible with dual PMODs, because they have different PMOD connector offset and variable (different) VCCIO voltage.

Power

Power Supply

Power supply with minimum current capability of 3A at 12V for system startup is recommended.

...

There are two baseboard supply voltages VIOTA and VIOTB connected to the 4 x 5 SoM's PL IO-bank. The supply-voltages have following pin assignments on B2B-connectors:

...

Table 4: Baseboard supply-voltages VIOTA and VIOTB

...

DateRevisionAuthorsDescription

Page info
modified-date
modified-date
dateFormatyyyy-MM-dd



John Hartfiel
  • Dual PMOD note
2017-11-09v.60John Hartfiel
  • add B2B connector section
2017-08-15

v.59

John Hartfiel
  • Add VCCIO Jumper Pin location.
  • Updated VADJ description.
2017-08-14v.58John Hartfiel
  • Description correction.
2017-05-25v.56Jan Kumann
  • New physical dimensions drawing of the board.
2017-05-16

v.51

Jan Kumann
  • A few overall improvements and corrections, new  block diagram.
2017-04-11

 

Ali Naseri
  • added block diagram
2017-02-15

v.45

Ali Naseri
  • added warning concerning the use of FTDI tools
2017-02-15v.40Ali Naseri
  • added power-on sequence diagram
2017-01-19

v.35

Ali Naseri
  • correction of table 3 (switch-positions to adjust FMC_VADJ)
  • inserted hint to set and measure the PL IO-bank supply-voltages
2017-01-13

v.20

Ali Naseri
  • added section for baseboard supply voltage configuration
2016-11-29
v.10

 

Ali Naseri
  • TRM update due to new revision 06 of
  • the carrier board.
2016-11-28v.4

Ali Naseri

  • TRM adjustment to the newest
  • revision (05) of TE0701 Carrier Board.
2014-02-18
0.2
Sven-Ole Voigt
  • TE0701-03 (REV3) updated
2014-01-05

0.1

Sven-Ole Voigt
  • Initial release
 AllSven-Ole Voigt, Ali Naseri 

...