Page History
...
Scroll Title | ||||||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||||||||||||||||||||||||
|
...
Scroll Title | ||||||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||||||||||||||||||||||||
|
- Barrel Jack, J12
- RJ45 socket, J8...9
- VGA Socket, J11
- Push button(Reset), S7
- Grove connector, J5
- Under/Over Voltage Protector, U9
- 7-segment LED, D11
- 1x6 pin header, J4
- 1x8 pin header, J2...3
- User Red LEDs, D2...9
- User Red LEDs, D13...17
- Push buttons, S1- S3...6
- Red LED (CONF_DONE), D10
- PSDRAM memory, U3
- SDRAM memory, U10
- Voltage Regulator, U5- U7
- AD/DA Convertor, U2
- Pmod 2x6 SMD host socket, P1...6
- Intel Cyclone 10 LP, U1
- Config Device, U5
- 1x10 pin header, J1
- EEEPROM, U15- U18- U20
- FTDI FT2232H, U14
- Micro USB 2.0 receotacle 90, J10
- Push button (RST_GPIO), S2
- Oscillator, U22
- Ethernet PHY, U17- U19
- SPI Flash memory, U12
Initial Delivery State
Page properties | ||||
---|---|---|---|---|
| ||||
Notes : Only components like EEPROM, QSPI flash and DDR3 can be initialized by default at manufacture. If there is no components which might have initial data ( possible on carrier) you must keep the table empty |
...
Overview
Content Tools