Versions Compared

Old Version 11

changes.mady.by.user Martin Rohrmüller

Saved on

compared with

New Version Current

changes.mady.by.user Martin Rohrmüller

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Scroll Title
anchorFigure_Overview
titleBoard Overview


Scroll Ignore
scroll-pdftrue
scroll-officetrue
scroll-chmtrue
scroll-docbooktrue
scroll-eclipsehelptrue
scroll-epubtrue
scroll-htmltrue

draw.io Diagram
bordertruefalse
viewerToolbartrue
fitWindowfalse
diagramDisplayName
lboxfalse
revision5
diagramNameTEF1002 Overview
simpleViewerfalse
width
linksauto
diagramWidthtbstyle641top
revisiondiagramWidth4636
draw.io Diagram
bordertruefalse
viewerToolbartrue
fitWindowfalse
diagramDisplayName
lboxfalse
revision4
diagramNameTEF1002_Overview_bottom
simpleViewerfalse
width
linksauto
diagramWidthtbstyle641top
revisiondiagramWidth3631


Scroll Only


  1. 4x5 module connectors
  2. Jumper J4 (VCCIOA)
  3. Jumper J7 (VCCA_SD)
  4. Dip switches S2 and S3
  5. 6-pin PCIe ATX Power Connector
  6. micro USB  connector for FTDI USB to JTAG/UART bridge
  7. Reset push button
  8. Power LED
  9. Status LED
  10. top load microSD card cage

Power supply

...

Scroll Title
anchorTable_DIP_PB
titleDIP Switches /Push Buttons

Scroll Table Layout
orientationportrait
sortDirectionASC
repeatTableHeadersdefault
style
widths
sortByColumn1
sortEnabledfalse
cellHighlightingtrue


DipSettingNote
S1
Push button configured by CPLD as reset

S2-1

OFF

OFF, OFF, OFF selects FMC _VADJ OFF. The choice OFF, ON, OFF selects 1.8V FMC_VADJ, which is a valid bank power for TE0720.


S2-2OFFON
S2-3OFF
S2-4OFFSelects 4x5 module SOC/FPGA JTAG
S2-5OFF
S2-6OFF
S2-7ONModule  power enable.
S2-8ONOFFUse extended Extended power sequenzing (if implemented).
S3-1OFFFor Zynq modules: Primary Boot Mode SD/QSPI. OFF corresponds to boot from SD card.
S3-2OFFOveride automatic enable FMC_VADJ.  (1)(2)


...

Page properties
hiddentrue
idComments

In this Section you must refer to the Reference Design (Test board) for the particular module.

For Example: TE0728 Reference Designs

  • Use e.g. the Test board Reference Design of the installed 4x5 module.
  • For TE0820 on this carrier TE0820 TD TEF1002, including PCIe endpoint and SATA, is available.

Notes

Page properties
hiddentrue
idComments

In this Section you must refer to the Resources Page for the particular module.

For Example: TE0728 Resources

...