Page History
This section describes the an exemplary boot process, which means that the output depends on the specific system and has not to be the same, with its stage-specific outputs as mentioned in page "Board bring-up overview for TEI0022". The first section describes an overview with the information at which point which boot stage is started. The second section shows an exemplary excerpt from a boot process.
Overview of the console output during the boot process
| Stage # | Stage Name | Line | Output Start |
|---|---|---|---|
| 1 | BootROM | No output | |
| 2 | Preloader | 1 | U-Boot SPL 2013.01.01 (Jan 02 2020 - 11:23:24) ... |
| 3 | Bootloader | 22 | U-Boot 2013.01.01 (Jan 06 2020 - 10:45:30) ... |
| 4 | Kernel | 49 | Starting kernel ... |
| 5 | Root Filesystem | 68 | Welcome to Poky (Yocto Project Reference Distro) 2.7.2 (warrior)! |
| 6 | Linux | 86 | Poky (Yocto Project Reference Distro) 2.7.2 arrow-sockit ttyS0 |
Exemplary Boot Process Console Output
| Code Block | ||||
|---|---|---|---|---|
| ||||
U-Boot SPL 2013.01.01 (Jan 02 2020 - 11:23:24) |
...
BOARD : Altera SOCFPGA Cyclone V Board |
...
CLOCK: EOSC1 clock 25000 KHz |
...
CLOCK: EOSC2 clock 25000 KHz |
...
CLOCK: F2S_SDR_REF clock 0 KHz |
...
CLOCK: F2S_PER_REF clock 0 KHz |
...
CLOCK: MPU clock 600 MHz |
...
CLOCK: DDR clock 333 MHz |
...
CLOCK: UART clock 100000 KHz |
...
CLOCK: MMC clock 50000 KHz |
...
CLOCK: QSPI clock 400000 KHz |
...
RESET: COLD |
...
INFO : Watchdog enabled |
...
SDRAM: Initializing MMR registers |
...
SDRAM: Calibrating PHY |
...
SEQ.C: Preparing to start memory calibration |
...
SEQ.C: CALIBRATION PASSED |
...
SDRAM: 2048 MiB |
...
ALTERA DWMMC: 0 |
...
U-Boot 2013.01.01 (Jan 06 2020 - 10:45:30) |
...
CPU : Altera SOCFPGA Platform |
...
BOARD : Altera SOCFPGA Cyclone V Board |
...
I2C: ready |
...
DRAM: 2 GiB |
...
MMC: ALTERA DWMMC: 0 |
...
In: serial |
...
Out: serial |
...
Err: serial |
...
Skipped ethaddr assignment due to invalid EMAC address in EEPROM |
...
Net: mii0 |
...
Warning: failed to set MAC address |
...
Hit any key to stop autoboot: 0 |
...
reading u-boot.scr |
...
** Unable to read file u-boot.scr ** |
...
Optional boot script not found. Continuing to boot normally |
...
reading zImage |
...
4584536 bytes read in 219 ms (20 MiB/s) |
...
reading socfpga.dtb |
...
19377 bytes read in 5 ms (3.7 MiB/s) |
...
## Flattened Device Tree blob at 00000100 |
...
Booting using the fdt blob at 0x00000100 |
...
reserving fdt memory region: addr=0 size=1000 |
...
Loading Device Tree to 03ff8000, end 03fffbb0 ... OK |
...
Starting kernel ... |
...
Uncompressing Linux... done, booting the kernel. |
...
[ 0.000000] Booting Linux on physical CPU 0x0 |
...
[ 0.000000] Linux version 4.9.0-g27c406b-dirty (soceds@ubuntu) (gcc version 5.5.0 (Linaro GCC 5.5-2017.10) ) #3 SMP Tue Mar 26 23:45:18 EDT 2019 |
...
[ 0.000000] CPU: ARMv7 Processor [413fc090] revision 0 (ARMv7), cr=10c5387d |
...
[ 0.000000] CPU: PIPT / VIPT nonaliasing data cache, VIPT aliasing instruction cache |
...
[ 0.000000] OF: fdt:Machine model: Trenz M Series Cyclone V SoC Development Kit |
...
[ 0.000000] Memory policy: Data cache writealloc |
...
[ 0.000000] percpu: Embedded 14 pages/cpu @eefcb000 s26944 r8192 d22208 u57344 |
...
[ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 522752 |
...
[ 0.000000] Kernel command line: console=ttyS0,115200 root=/dev/mmcblk0p2 rw rootwait |
...
... |
...
... Skipping |
...
lines until the last one ... |
...
... |
...
[ 1.849673] systemd[1]: Detected architecture arm. |
...
Welcome to Poky (Yocto Project Reference Distro) 2.7.2 (warrior)! |
...
[ 1.888466] systemd[1]: Set hostname to <arrow-sockit>. |
...
[ 2.113176] systemd[1]: File /lib/systemd/system/systemd-journald.service:12 configures an IP firewall (IPAddressDeny=any), but the local system does not support BPF/cgroup based firewalling. |
...
[ 2.130237] systemd[1]: Proceeding WITHOUT firewalling in effect! (This warning is only shown for the first loaded unit using IP firewalling.) |
...
[ 2.444313] systemd[1]: Listening on udev Control Socket. |
...
[ OK ] Listening on udev Control Socket. |
...
[ 2.486269] systemd[1]: Listening on Syslog Socket. |
...
[ OK ] Listening on Syslog Socket. |
...
[ 2.517683] systemd[1]: Started Forward Password Requests to Wall Directory Watch. |
...
[ OK ] Started Forward Password R???uests to Wall Directory Watch. |
...
... |
...
... Skipping |
...
lines until the last one ... |
...
... |
...
[ OK ] Started Update UTMP about System Runlevel Changes. |
...
Poky (Yocto Project Reference Distro) 2.7.2 arrow-sockit ttyS0 |
...
arrow-sockit login: |
Overview
Content Tools