Table of Contents
Overview
Module Overview
Power supply
Single 5V power supply with minimum current capability of 2.5A is recommended to operate the board.
DIP-Switches and Push Buttons
There is a switch S1 which is connected to RESET signal which resets the system entirely.
Signal | Designator | B2B | Active Level |
|---|---|---|---|
RESET | S1 | J2-7 | Active High |
DIP Switchs and Push Buttons
There are no DIPs on TE0728. In case of TE0790 (XMOD) usage, see power supply section.
Jumpers
| Designator | Connected to | B2B | Note |
|---|---|---|---|
| J4 | Boot_R | J2-11 | Open: QSPI |
| Short: SD Card |
On-board Jumpers
LEDs
There are three user LEDs which can be used for variant purposes.
| Designator | Color | Connected to | B2B | Active Level | Note |
|---|---|---|---|---|---|
| D1-A | Red | MIO48 | J2-30 | Active high | |
| D1-B | Yellow | MIO49 | J2-38 | Active high | |
| D1-C | Green | MIO50 | J2-36 | Active high |
On-board LEDs
JTAG/UART
JTAG and UART is possible over miro USB connector.
miroUSB UART is connected to PL IO (RX: Pin H13, TX: Pin H14).
Reference Designs
Notes
Overview
Content Tools