Table of Contents
TEBF0808 with TE080x
Overview
Board Overview
Power supply
DIP-Switches and Push Buttons
DIP Switches /Push Buttons
Jumpers
Jumpers
LEDs
Carrier LEDs
Furthermore, there are two user LEDs on module TE0728.
Designator | Color | Connected to | Note |
---|---|---|---|
D1 | Red | DONE signal (PS Configuration Bank 503) | This LED goes ON when power has been applied to the module and stays ON until MPSoC's programmable logic is configured properly. |
Module LEDs
JTAG/UART
SoC JTAG and UART connections are available through XMOD JTAG adapter with the green dot on J12. For more information refer to TE0790.
DIP Switch on the XMOD JTAG adapter must be set like the following table.
DIP Switch | Setting |
---|---|
1 | ON |
2 | OFF |
3 | OFF |
4 | OFF |
XMOD JTAG DIP Switch. Attention: Never changes the default setting
Reference Designs
Notes
Module and Carrier are also as starter kit available:
Overview
Content Tools