You are viewing an old version of this page. View the current version.
Compare with Current
View Page History
Version 1
Next »
To configure a TE0320 module via USB bus, there are different procedures to follow according to module status and purpose of use. For instance, a full quality control test already performed at Trenz Electronic laboratory premises requires all the following steps to be performed:
- generic USB device driver installation
- USB FX2 microcontroller large EEPROM programming
- specific USB device driver installation
- a *.iic file generation
- a firmware upgrade tool (Cypress tools: CyConsole or CyControlCenter TE tools: OpenFut, OpenFutNet or FX2EEPROMProgrammer) utilization.
step |
first
development
cycle |
following
development
cycles |
EEPROMrecovery |
quality
control
(lab test) |
(a) |
|
|
â— |
â— |
(b) |
|
|
â— |
â— |
(c) |
â— |
|
|
â— |
(d) |
â— |
â— |
|
â— |
(e) |
â— |
â— |
|
â— |
Table 24: configuration steps via USB bus according to module status and purpose of use.