You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

To see the device status you should open "Device Manager" using one of this two procedure:
  • Start\Control Panel\System and Security\System\Device Manger
  • write devmgmt.msc in the line “Search programs and files” to go directly to the Device Manager

If the TE0300 module is used, the S2 switch must be turned on (RUN).

If the TE0320 module is used, the S1D switch must be turned on (RUN).

 

DEWESoft device (Generation 2)

TE USB FX2 module starts as a DEWESoft device (at power on) (Generation 2) when

  1. Generation 2 firmware is correctly stored in FX2 microcontroller's EEPROM;
  2. the EEPROM connection is enabled when the TE USB FX2 module is powered on.
  • DEWESoft driver is not installed
  • DEWESoft driver is installed

    OR (if you have installed the previous version of driver).

TE device (Generation 3)

TE USB FX2 module starts as a TE device (at power on) (Generation 3) when

  1. Generation 3 firmware is correctly stored in FX2 microcontroller's EEPROM;
  2. the EEPROM connection is enabled when the TE USB FX2 module is powered on.
  • TE USB FX2 driver is not installed.
  • TE USB FX2 driver is installed.

Cypress device (Recovery procedure)

TE USB FX2 module starts as a Cypress device (at power on) when

  1. the EEPROM connection is disabled when the TE USB FX2 module is powered on.
  • No labels