Update Boot (TE USB FX2 Firmware Update)

Created by Sergio Pavesi, last modified on 14 11, 2013

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

An update boot (aka TE USB FX2 firmware update), for Generation 3 firmware, is a multi-step boot operation:

follow the same procedure of TE USB FX2 driver installation (Generation 3);
check that EEPROM connection is enabled (EEPROM switch is set in a way to enable EPPROM connection to USB FX2 microcontroler);

EEPROM connection shall always be enabled during EEPROM programming.

Cypress firmware update tools and OpenFutNet can read and write the EEPROM using:

See also Cypress USB Control Center update boot and Cypress USB Console update boot videos for further information about the procedures to follow.

For Generation 2 (not advised), it is possible to update the Generation 2 firmware using Open_FUT (gen 2) and Generation 2 driver.

No labels