The Trenz Electronic TE0725 is a low cost small-sized FPGA module integrating a Xilinx Artix-7 (15-100T) and 32 MByte Flash memory for configuration and operation. The 2 x 50 pin headers with a 2,54mm standard pitch are perfect for breadboard or low cost dual layer PCB.
Xilinx Artix-7 XC7A35T (A15 to A100T)
commercial temperature grade (industrial on request)
32 MByte Flash memory
2 x 50 pin headers with 2,54mm pitch, ideal for breadboard use
- 87 IO's (42 + 42 + 3)
- 100 MHz System Clock
- I2C EEPROM
3.3V single supply with on board voltage regulators
Size 73 x 35 mm
JTAG connector
2 LEDs
- optional HyperRAM (8 to 32 MByte)
- optional Fiber Optic modul (125/250 or 1000MBit/s)
IO Banks
Bank | VCCIO | B2B I/O | Notes |
---|---|---|---|
0 | 3.3V | 0 | JTAG |
14 | 3.3V | 0 (3) | 3 I/O in XMOD-JTAG |
15 | 1.8V | 0 | used for optional hyper RAM |
16 | 2.5V | 0 | used for optional optical fiber |
34 | User select | 42 | 0R resistor option to select 3.3V |
35 | User select | 42 | 0R resistor option to select 3.3V |
LED's
LED | Color | FPGA | |
---|---|---|---|
D2 | green | M16 | |
D3 | red | DONE | Active Low |
Connectors
JTAG/Debug
Connector JB1 (2 x 6 pin Header) is directly compatible to XMOD JTAG Adapter TE0790, this adapter can be inserted from top onto the TE0725, if JB1 is fitted with male pin header. Optionally JB1 can be fitted with pin header from bottom, in that case the JTAG cable connector must be on the base board.
When using XMOD-JTAG in JB1 then additionally USB UART is usable, and the push-button on XMOD works as configuration reset.
Technical Specification
Power
Single 3.3V Power supply required.
FPGA | Design | Typical Power, 25C ambient |
---|---|---|
A35T | not configured | TBD |
A35T | LED Blinky | 170mW |
A100T | not configured | TBD |
Typical power consumption
Connectors
Measurements and placement of the connectors and mounting holes. All 100 mil pin headers are in 100 mil grid, the M3 mounting holes are in 50 mil grid aligned to the centers of the 100mil headers. The module is symmetrical, turning it 180 degrees will keep all I/O and Power Pins in both 50 pin headers in compatible places.