The Trenz Electronic TE0729 is an industrial-grade SoM (System on Module) based on Xilinx Zynq-7000 SoC (XC7Z020).
This SoM has following peripherals on board:
All modules in 4 x 5 cm form factor are mechanically compatible.
Assembly options for cost or performance optimization available upon request.
Special purpose pins used by TE0729
Name | Note |
---|---|
NRST | |
NRST_IN |
By default the TE-0729 supports QSPI-Flash-Memory, JTAG and SD-Card (if available on base board) boot modes.
The boot modes are controlled by the Pins 'BOOT1' and 'BOOT2' on the board to board (B2B) connector.
Pin-State BOOTMODE1 / BOOTMODE2 | boot mode |
---|---|
LOW / LOW | |
LOW / HIGH | |
HIGH / LOW | |
HIGH / HIGH |
JTAG access to the Xilinx Zynq-7000 device is provided by connector J2.
Signal | B2B Pin |
---|---|
TCK | J2: 119 |
TDI | J2: 115 |
TDO | J2: 117 |
TMS | J2: 113 |
JTAGEN pin in JM1 should be kept low or grounded for normal operation.
Clock | Frequency | IC | FPGA | Notes |
---|---|---|---|---|
PS CLK | 33.3333 MHz | U14 | PS_CLK | PS Subsystem main clock |
10/100/1000 Mbps ETH PHY reference | 25 MHz | U10 | - | |
USB PHY reference | 52 MHz | U12 | - |
Peripheral | IC | Designator | PS | MIO | Notes |
---|---|---|---|---|---|
EEPROM I2C | U8 | 24AA025E48T-I/OT | I2C0 | MIO10, MIO11 | MAC1-Adress |
EEPROM I2C | U9 | 24AA025E48T-I/OT | I2C0 | MIO10, MIO11 | MAC2-Adress |
EEPROM I2C | U20 | 24AA025E48T-I/OT | I2C0 | MIO10, MIO11 | MAC3-Adress |
RTC | |||||
RTC Interrupt | |||||
SPI Flash | |||||
Clock PLL | |||||
Ethernet | |||||
USB | |||||
LED | |||||
USB Reset | |||||
Ethernet Reset |
MIO | Configured as | B2B | Notes |
---|---|---|---|