TRM TE0729

Overview

The Trenz Electronic TE0729 is an industrial-grade SoM (System on Module) based on Xilinx Zynq-7000 SoC (XC7Z020).

This SoM has following peripherals on board:

1 x Gbps Ethernet Phy transceiver
2 x 100 Mbps Ethernet PHY transceivers
512 MByte DDR3 SDRAM
32 MByte Flash-Memory
4 Gbyte NAND-Flash-Memory
USB PHY transceiver
powerful switch-mode power supplies for all on-board voltages
large number of configurable I/Os is provided via rugged high-speed stacking strips

All modules in 4 x 5 cm form factor are mechanically compatible.

Industrial-grade Xilinx Zynq-7000 (XC7Z020) SoM
Rugged for shock and high vibration
2 x ARM Cortex-A9
1 x 10/100/1000 Gbps Ethernet transceiver PHY
2 x 10/100 Mbps Ethernet transceiver PHYs
3 x MAC-Address EEPROMs
16-Bit wide 512 MByte DDR3 SDRAM
32 MByte QSPI-Flash-Memory
4 GByte NAND-Flash-Memory (embedded eMMC Memory)
Programmable Clock Generator
- Transceiver Clock (default 125 MHz)
USB 2.0 high-speed ULPI transceiver
4 GTP/GTX (high-performance transceiver) lanes
- GTP/GTX (high-performance) clock input
Plug-on module with 2 x 120-pin high-speed hermaphroditic strips
136 FPGA I/Os (58 LVDS pairs possible) and 6 PS MIO available on board-to-board connectors
On-board high-efficiency DC-DC converters
- 4.0 A x 1.0 V power rail
- 1.5 A x 1.5 V power rail
- 1.5 A x 1.8 V power rail
- 1.5 A x 2.5 V power rail
System management
eFUSE bit-stream encryption
AES bit-stream encryption
Temperature compensated RTC (real-time clock)
User LED
Evenly-spread supply pins for good signal integrity

Assembly options for cost or performance optimization available upon request.

Special purpose pins used by TE0729

Name	Note
NRST
NRST_IN

By default the TE-0729 supports QSPI-Flash-Memory, JTAG and SD-Card (if available on base board) boot modes.

The boot modes are controlled by the Pins 'BOOT1' and 'BOOT2'.

Pin-Configuration BOOTMODE1 / BOOTMODE2	boot mode
LOW / LOW
LOW / HIGH
HIGH / LOW
HIGH / HIGH