DIPFORTy1 "Soft-Propeller"

2015 First year an Xilinx 7 series based product or Zynq based product passed into semifinals for the   HackdaDay prize Trip To Space   A small step for those on the way to All Programmable ... ... world?

DIPFORTy1 PINOUT

Pinout for Parallax Propeller compatible names

TOP Side	Bottom Side

Features

• Xilinx ZYNQ-7: XC7Z010-CLG225
  • 16 MByte SPI Flash (primary boot)
  • 33.333 MHz Clock (MEMS oscillator)
• DIP40 form factor
  • 2 x 20 holes for socket pins or pin-header
  • Size: 18 x 51 mm
• Total user accessible PL I/O: 46 (+3 Input only)
  • DIP40 header pins: 34 I/O
  • XMOD J1: 6 I/O
  • XMOD J2: JTAG + 2 I/O (or 3 input + 2 I/O)
  • XMOD J3: 4 I/O
• 3.3V single supply
• RGB LED (PL I/O connected)
• "Done" LED (inverted polarity)
• User LED (ARM CPU MIO GPIO)
• MicroSD card socket (MIO, ZYNQ secondary boot media)
• Sil1143 Proximity and ambient light sensor

JTAG Header

TE0722 JTAG Connector J2 -TOP view

Use XMOD - Programmer

XMOD Programmer can be used as JTAG-Programmer and UART Interface.

JTAG header pinout using "alternate" mapping for XMOD-FT2232 JTAG adapter. This mapping, if needed can be changed by reprogramming the XMOD-CPLD. Connect XMOD on the top side of the PCB (Side with FPGA and module name). Use XMOD Pin 1 to 10.

If TE0722 is powered via XMOD (max. ~ 100mA), use XMOD DIP-Switch:

If TE0722 is powered with external 3.3V, use XMOD DIP-Switch:

For more details and downloads see:

• Xmod-FT2232H
• XMOD-Downloads

Use other JTAG - Programmer

For example Xilinx Platform Cable USB2 or Digilent XUP USB-JTAG Programming Cable.

If you use a other programming cable than XMOD, TE0722 need a external 3.3V power supply. Use following connection: