Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 5 Current »



Quick Start

Arrow-USB-Blaster should be fully compatible to original USB Blaster with the exception that only JTAG mode is supported. Pin-out is compatible, JTAG Voltage range is limited to max 3.3V. JTAG interface on most Intel(Altera) based boards is designed so that the original USB-Blaster cable when inserted goes away from the board, same with Arrow USB Blaster2, when inserted so that USB cable goes away from the PCB then it is correct. Pin 1 in the 2x5 Female header is also marked with white dot.

Software Support

One time installation of Quartus support libraries is needed. There are no custom USB drivers needed, WHQL certified Drivers from FTDIChip are used.


  • No labels