In this section you must explain how to power on the board and run the Reference Design (test board) on the particular module. The main points must be mentioned are:
|
Table of Contents |
Basic instructions to work with TEIB0006 and TEI0006.
Functionality of buttons, DIP switches, LEDs depends on CPLD Firmware. Following description is only for newest firmware version, which is available on the download area |
Number | Note |
---|---|
1 | J1/3 - SFP+ connector |
2 | J14 - CRUVI connector |
3 | J12 - Power Jack, 2.0mm, DC (12V power input) |
4 | J5 - RJ45 Ethernet Connector |
5 | J5 - RJ45 Ethernet Connector LED yellow |
6 | J5 - RJ45 Ethernet Connector LED green |
7 | D1 - LED red (Usage: status led) || D2 - LED green || D3 - LED green || D4 - LED green |
8 | J8 - USB 2.0 Micro B Receptacle |
9 | J13 - USB 3.0 Micro B Receptacle |
10 | S1 - DIP Switch for JTAG access and write protection for EEPROM U13 on TEIB0006 |
11 | S5 - reset button for Intel MAX 10 on TEI0006 |
12 | S4 - user button |
13 | S3 - reset button for Intel Cyclone 10 GX on TEI0006 |
14 | D2 - LED red || D3 - LED red || D4 - LED green |
15 | J6 - FMC HPC connector |
The input power supply must be mentioned. Add Link to overview picture with connector label. |
Label | Designator | Supply Voltage | Description |
---|---|---|---|
Overview - 3 | J12 | 12V | Single 12V power supply |
Current depends mainly on design and cooling solution. Use Quartus Power Analyzer Tool and/or Your Quartus Project to estimate min current. Minimum of 1A are recommanded for basic functionality.
Explain all DIP switches functionality. Add Link to overview picture with connector label. |
|
*Note: Reset button S5 is not Firmware depended |
Explain all user LEDs functionality and connections. Add Link to overview picture with connector label. |
*Note: LED D4 is not Firmware depended |
|
Label | Designator | Description |
---|---|---|
Overview - 8 | J8 | JTAG/UART over USB, UART Speed depends on design, normally 115200 |
Firmware update instruction and Firmware description are available on TEI0006 Intel MAX 10 Firmware. Source code of the firmware is available on the download area of the TEI0006.
In this Section you must refer to the Reference Design (Test board) for the particular module. For Example: TEI0006 Reference Designs |
Link to different Reference Designs (Descriptions and Download)
It's recommended to use prebuilt *.jic file of newest Reference Design for first test. Basic Steps:
In this Section you must refer to the Resources Page for the particular module. For Example: TEI0006 Resources |
Links to all documentation and download resources: