In this section you must explain how to power on the board and run the Reference Design (test board) on the particular module. The main points must be mentioned are:

  • Overview of the board (point out the LEDs, Ethernets, Switches and etc on the board overview)
  • Explain Switches functionality
  • Explain user LEDs

  • Explain the UART connection

  • Refer to the Reference Design

    For more information regarding how to draw a diagram, Please refer to "Diagram Drawing Guidline" .



Table of Contents

TEBF0808 with TE080x

Overview




  1. TODO

Power supply

The input power supply must be mentioned. Add Link to overview picture with connector label.


DIP-Switches and Push Buttons

Explain all DIP switches functionality. Add Link to overview picture with connector label.




Jumpers

Explain all Jumpers functionality and connection. Add Link to overview picture with connector label.



LEDs

Explain all user LEDs functionality and connections. Add Link to overview picture with connector label.



Furthermore, there are two user LEDs on module TE0728.

DesignatorColorConnected toNote
D1RedDONE signal (PS Configuration Bank 503)

This LED goes ON when power has been applied to the module and stays ON until MPSoC's programmable logic is configured properly.


JTAG/UART

Explain JTAG or UART connection . Add Link to overview picture with connector label.

SoC JTAG and UART connections are available through XMOD JTAG adapter with the green dot on J12. For more information refer to TE0790.

DIP Switch on the XMOD JTAG adapter must be set like the following table.

DIP SwitchSetting
1ON
2OFF
3OFF
4OFF


Reference Designs

In this Section you must refer to the Reference Design (Test board) for the particular module.

For Example: TE0728 Reference Designs

Notes

In this Section you must refer to the Resources Page for the particular module.

For Example: TE0728 Resources

Module and Carrier are also as starter kit available: