Template Revision 2.5
|
<!-- tables have all same width (web max 1200px and pdf full page(640px), flexible width or fix width on menu for single column can be used as before) --> <style> .wrapped{ width: 100% !important; max-width: 1200px !important; } </style> |
Important General Note:
|
----------------------------------------------------------------------- |
Note for Download Link of the Scroll ignore macro:
|
Table of Contents |
The Trenz Electronic TEBT0808 is a test fixture for module TE0808(REV01, REV02) and TE0803(REV01) series.
Refer to http://trenz.org/tebt0808-info for the current online version of this manual and other available documentation.
Notes :
|
Note: |
add drawIO object here.
|
Notes :
|
Notes : Only components like EEPROM, QSPI flash and DDR3 can be initialized by default at manufacture. If there is no components which might have initial data ( possible on carrier) you must keep the table empty |
|
|
Boot mode can be set by DIP-Switch S1.
|
|
Notes :
|
FPGA bank number and number of I/O signals connected to the B2B connector:
|
JTAG access to the TEBT080X is available through B2B connector JM2 using XMOD JTAG adapter TE0790 adapter.
|
There is a DIP switch on TE0790 adapter which must be set accordingly.
|
The voltages 3.3V (VCC) and VIO (variable SC CPLD I/O-voltage) can be configured by the DIP-switches 3 and 4:
|
PJTAG access to the TEBT0808 is available through B2B connector JM3.
|
I2C signals can be accessed through pin header J5.
|
|
|
Notes :
|
Notes : In the on-board peripheral table "chip/Interface" must be linked to the corresponding chapter or subsection |
|
There are thre DIP Switches, S1, S2, S3.
The Boot Mode can be set through DIP Switch S1, refer to BootMode table.
|
Control signals must be set using DIP Switch S2, S3.
|
|
|
|
In 'Power and Power-on Sequence' section there are three important digrams which must be drawn:
|
|
Minimum current depends mainly on design and cooling solution. Use Xilinx Power Estimator and/or Your Vivado Project to estimate min current. Minimum of 3A are recommanded for basic functionality.
|
* TBD - To Be Determined
Input oower sourced directly the module, Only one Diode D1 is used for protection.
|
|
|
Operating temperature range depends also on customer design and cooling solution. Please contact us for options.
|
Module size: 90 mm × 90 mm. Please download the assembly diagram for exact numbers.
Mating height with standard connectors: 3.5 mm.
PCB thickness: 1.6 mm.
In 'Physical Dimension' section, top and button view of moduloe must be insterted, information regarding physical dimention can be obtained through webpage for product in Shop.Trenz, (Download> Documents> Assembly part)for every SoM. For Example: for Module TE0728, Physical Dimension information can be captured by snipping tools from the link below:
|
Set correct link to the shop page overview table of the product on English and German. Example for TE0728: ENG Page: https://shop.trenz-electronic.de/en/Products/Trenz-Electronic/TE07XX-Zynq-SoC/TE0728-Zynq-SoC/ DEU Page: https://shop.trenz-electronic.de/de/Produkte/Trenz-Electronic/TE07XX-Zynq-SoC/TE0728-Zynq-SoC/ if not available, set. |
|
|
|
|