In this section you must explain how to power on the board and run the Reference Design (test board) on the particular module. The main points must be mentioned are:
|
Table of Contents |
The input power supply must be mentioned. |
Single 12V power supply with minimum current capability of 3A is recommended to power on the board via the 6-pin PCI-E ATX connector.
Explain all DIP switches functionality. |
Select dip switch settings according to the attached 4x5 module and your needs. Compare Dip switch setting with TRM of your module and table in TRM of TEF1002. Following a general configuration is shown.
|
Explain all Jumpers functionality and connection. |
For Jumper J7 compare TRM of actually used 4x5 module. The voltage of the bank where the SDIO signals are connected has to selected. J4 selects the module bank voltage VCCIOA. It has to be selected in accordance with IO voltage of signals connected to FFA and FFB. If both FFA and FFB are not used any setting is ok. Do not leave open (communication of 4x5 module with TEF1002 CPLD is only possible with availabe VCCIOA)!
|
Explain all user LEDs functionality and connections. |
There are four LEDs on the board. Compare corresponding table in TEF1002 TRM.
|
Explain JTAG or UART connection breifly. |
JTAG(first FTDI port) and UART(second FTDI port) is over MicroUSB connector available. External JTAG Programmer is not needed.
In this Section you must refer to the Reference Design (Test board) for the particular module. For Example: TE0728 Reference Designs |
In this Section you must refer to the Resources Page for the particular module. For Example: TE0728 Resources |