Template Revision 1.0 - on construction For carrier - module combination, create main getting started page for carrier Design Name always "TE Series Name" +Getting Started, for example "TE0701 Getting started" and add carrier/module combination in the description → link on the module resource page also For whole board, use the board name, for example "TEBF0911 Getting Started" |
In this section you must explain how to power on the board and run the Reference Design (test board) on the particular module. The main points must be mentioned are:
|
Table of Contents |
Basic instructions to work with TEI0022.
Functionality of buttons, DIP switches, and LEDs depends on CPLD Firmware. |
Number | Note | Number | Note |
---|---|---|---|
1 | U10 - Intel Cyclone V | 15 | J5 - Micro USB for UART |
2 | U26...27 - DDR3 for Fabric | 16 | U21 - USB to JTAG FTDI |
3 | U28...29 - DDR3 for HPS | 17 | J13 - Micro USB for JTAG |
4 | J4 - FMC | 18 | J7...10 / J15 / J17...18 - SMA Connector |
5 | P1...4 - PMOD | 19 | S1, S3...5 - Button |
6 | J3 - SD Card | 20 | LEDs |
7 | U1 - Ethernet PHY | 21 | S2 / S7...8 - DIP Switch |
8 | J1 - Ethernet RJ45 | 22 | J6 - Power Jack |
9 | U8 - USB PHY | 23 | U48 - Oscillator |
10 | U33 - USB HUB | 24 | U3 - Programmable Clock Generator |
11 | J2/ J12 - USB Connector | 25 | U6 - QSPI |
12 | U23 - HDMI Transmitter | 26 | U15 - QSPI |
13 | J11 - HDMI Connector | 27 | U54 - Power Monitoring |
14 | U41 - Intel MAX 10 | 28 | U38 - EEPROM |
The input power supply must be mentioned. |
Single +12.0 V power supply is needed to power on the board at power jack J6. Current depends mainly on design and cooling solution. Use Intel Power Estimator and/or your Intel Quartus Prime Project to estimate min current. Minimum of 3A are recommended for basic functionality.
Explain all DIP switches functionality. |
There are three four-bit dip switches and four buttons, explained in the following:
|
|
|
|
Explain all user LEDs functionality and connections. |
The LED functionality is explained in the following:
|
Explain JTAG or UART connection breifly. |
JTAG and UART connections are available through mini USB connectors.
|
In this Section you must refer to the Reference Design (Test board) for the particular module. For Example: TE0728 Reference Designs |
In this Section you must refer to the Resources Page for the particular module. For Example: TE0728 Resources |