Table of Contents
Overview
Module Overview
Power supply
Single 5V power supply with minimum current capability of 2.5A is recommended to power on the board the board.
DIP-Switches and Push Buttons
There is a switch (S1) which is connected to RESET signal, it resets the system entirely.
Signal | Designator | B2B | Active Level |
|---|---|---|---|
RESET | S1 | J2-7 | Active High |
DIP Switchs and Push Buttons
There is no DIPs on TE0728. In case of TE0790 (XMOD) usage, see DIPs mode.
Jumpers
The Bootmode must be set to the SD card because the petalinux must be boot from SD card, In order to change the jumper setting to SD card zou should set the jumper to short circuit.
| Designator | Connected to | B2B | Note |
|---|---|---|---|
| J4 | Boot_R | J2-11 | Open: QSPI |
| Short: SD Card |
On-board Jumpers
LEDs
There are three user LEDs which can be used for variant purposes.
| Designator | Color | Connected to | B2B | Active Level | Note |
|---|---|---|---|---|---|
| D1-A | Red | MIO48 | J2-30 | Active high | |
| D1-B | Yellow | MIO49 | J2-38 | Active high | |
| D1-C | Green | MIO50 | J2-36 | Active high |
On-board LEDs
JTAG/UART
JTAG and UART connections are available through mini USB connector.
| Designator | Connected to | B2B Pin | XMOD Header JB1 | Direction | Note |
|---|---|---|---|---|---|
| UART Txd | MIO52 | J2-15 | JB1-3 | Input | Transfer |
| UART Rxd | MIO53 | J2-16 | JB1-7 | Output | Receive |
UART
Reference Designs
Notes
Overview
Content Tools