• Last modified: Jul 06, 2026

This document provides a brief overview of the required board configuration (DIP switches, jumpers, etc.) for each supported module when used with the TE0706 carrier board. It describes the settings required for each module, including the boot mode configuration where applicable.

DIP/Jumper/ButtonTE0706-04TE07...

TE0821-02/TE0820-04

TE08...
S1
DIP*Description
S1-1(A)Boot Mode 2 (PGOOD) 
S1-2(B)CPLD Access (PROGMODE)
S1-3(C)Boot Mode 1 (Mode)
S1-4(D)Power Enable (EN1)

 * Close Dip (ON) will force to GND



Boot Mode*QSPI SD eMMCJTAG 
S1-1OFFOFFONON
S1-3OFFONOFFON


JTAG MUXModule CPLDModul SoC
S1-2OFFON


PowerModul Power ONModul Power OFF
S1-4OFFON

 * Module CPLD Firmware depended


S2Reset, push button will force to GND
SoC POR_B via TPS supervisor
J9VBAT (optional)
powered only by carrier，PS battery backup supply pin
J10-J12

VCCIO Power supply

JumperB2B Bank Pin
J10/12 (VCCIOA)JB1-10
J11-VCCIOC)JB2-6
J12-VCCIOD)JB2-8/10
fix 1.8V-VCCIOB)JB2-2/4

(2-3=3.3V/1-2=1.8V)



Jumper1.8V3.3V
J10 (JM1-9/11 VCCO_HD25_26)1-22-3
J11 (JM2-5 VCCO_65)1-2do not use, out off range!
J12 (JM2-7/9 VCCO_HD24_44)1-22-3
JM2-1/3not connectednot connected



J13SD Level Shifter (2-3=3.3V/1-2=1.8V)


Jumper1.8V3.3V
J13do not use2-3



TE0790 

USB to JTAG/UART Interface

TE0790 CPLDDIP
S1-1ON
S1-2OFF
S1-3OFF
S1-4ON

default configuration for TE0706




CPLD Dependencies

no

  • carrier without CPLD

yes


HW Revision Dependencies

TE0706 PCN

yes, for older revisions:

  • different signal names
  • S1-1 not connected to PGOOD

TE0821 Product Change Notifications

yes

  • different connection to CPLD, see CPLD dependencies

TE0820 Product Change Notifications

yes

  • different connection to CPLD, see CPLD dependencies