Table of contents


Intel MAX 10 Access

  1. Set JTAGEN DIP switch S8D to ON
  2. Connect your USB cable to USB connector J13

Available Firmware

Download

  • TEI0022/<PCB Revision>/Firmware/
    • Use files from the subfolders of your PCB revision

General Instructions

MAX 10 Firmware Update - General Requirements

  • Quartus Prime software, available for free (lite version) on https://www.intel.de/
  • Arrow USB Programmer Driver
  • Quartus compatible JTAG programmer, for example:
    • TEI0004 - Arrow USB Programmer2 or carrier board with FTDI for JTAG
    • Other JTAG Programmer compatible with Quartus Programmer
  • JTAG must be connected to FPGA JTAG
  • Correct Firmware (*.pof file) from Download area

MAX 10 Firmware Update - General Procedure

Important:

  • Connect only one JTAG device to host PC.
  • Close all other JTAG programs.

Procedure:

  1. Enable FPGA JTAG access (see JTAG section on Firmware description)
  2. Connect JTAG
  3. Power on system
  4. Open Quartus Prime
  5. Open Quartus Programmer from top menu: Tools → Programmer
  6. Select from Programmer top menu: Edit → Hardware Setup
  7. Select via the drop down menu: Arrow-USB-Blaster [USB0] (Installation of Arrow USB Programmer needed) and close the window
  8. Click Add File...
  9. Select correct Firmware from Download area and press Open
  10. Click Start to program the device

More information are available on the Firmware description.

  • No labels