Table of Contents
TEB0728 with TE0728
Overview
Board Overview
- Barrel Jack Power Supply
- XMOD JTAG Adapter
- SD card holder
- Reset
- Boot mode Jumper
- Carrier LEDs (Red,Yellow,Green) D1
- Ethernet Socket
- Module LEDs (Green D4, Red D8)
Power supply
Single 5V power supply with minimum current capability of 2.5A is recommended to power on the board.
DIP-Switches and Push Buttons
There is a switch (S1) which is connected to RESET signal, it resets the system entirely.
Signal | Designator | B2B | Active Level |
|---|---|---|---|
RESET | S1 | J2-7 | Active High |
DIP Switches /Push Buttons
There is no DIPs on TE0728. In case of TE0790 (XMOD) usage, see DIPs mode.
Jumpers
| Designator | Connected to | B2B | Note |
|---|---|---|---|
| J4 | Boot_R | J2-11 | Open: QSPI |
| Short: SD Card |
Jumpers
LEDs
There are three user LEDs on the carrier TEB0728 which can be used for variant purposes.
| Designator | Color | Connected to | B2B | Active Level | Note |
|---|---|---|---|---|---|
| D1-A | Red | MIO48 | J2-30 | Active high | |
| D1-B | Yellow | MIO49 | J2-38 | Active high | |
| D1-C | Green | MIO50 | J2-36 | Active high |
Carrier LEDs
Furthermore, there are two user LEDs on module TE0728.
| Designator | Color | Connected to | B2B | Active Level | Note |
|---|---|---|---|---|---|
| D4 | Green | Bank33 pin V18 | - | Active high | |
| D8 | Red | MIO7 | - | Active high |
Module LEDs
JTAG/UART
JTAG and UART connections are available through XMOD JTAG adapter. For more information refer to TE0790.
DIP Switch on the XMOD JTAG adapter must be set like the following table.
| DIP Switch | Setting |
|---|---|
| 1 | ON |
| 2 | OFF |
| 3 | OFF |
| 4 | ON |
XMOD JTAG DIP Switch
Reference Designs
Notes
Overview
Content Tools