Page History

...

1. Xilinx ZYNQ XC7Z010 SoC, U1
2. 4 Gbit DDR3L 256M x 16 SDRAM, U2
3. 16 MByte QSPI Flash memory, U5

4. High-speed CMOS logic analog multiplexer/demultiplexer, U10

5. 1 MHz low-power operational amplifier, U11
6. Dual high-speed USB to multipurpose UART/FIFO, U3
7. 0.5A dual channel current-limited power switch, U21
8. Low-power programmable oscillator @ 12.000000 MHz, U7
9. 2 Kbit Microwire compatible serial EEPROM, U6
10. 10-pin header, J1
11. 8-pin header, J2
12. 10-pin header, J3
13. Analog input header, J4
14. 2 x 4 pin header, J5
15. PMod 2x6 interface header, J6
16. USB host mode jumper, J7
17. Micro USB 2.0 Type-B receptacle, J8
18. Micro USB 2.0 Type-B receptacle, J9
19. Micro SD card connector with detect signal, J10
20. Analog input select jumper, J11
21. 5V supply power, J12
22. Reset switch, S1
23. Red LED, D2
24. Green LED, D6
25. Green LED, D7
26. Ultra-low supply-current voltage monitor, U23

27. 1A PowerSoC DC-DC converter (3.3 V), U20

28. 1A PowerSoC DC-DC converter (1.8 V, U19
29. 1A PowerSoC DC-DC converter (1.35 V), U16
30. Hi-speed USB 2.0 ULPI transceiver, U18
31. Low-power programmable oscillator @ 52.000000 MHz, U14
32. 1A PowerSoC DC-DC converter (1.0 V), U17
33. JTAG interface testpoints, TP1-TP4

...

Signals, Interfaces and Pins

I/O Signals

List of I/O signals between PS/PL banks and external connectors:

...

On-board Peripherals

Processing System (PS) Peripherals

Clocking

Power and Power-On Sequence

Power Supply

Single 5V power supply with minimum current capability of 2A for system startup is recommended.

Power Consumption

TBD - To Be Determined.

Power-On Sequence

There is no sequence...

Technical Specifications

Absolute Maximum Ratings

...