Versions Compared

Old Version 3

changes.mady.by.user Thorsten Trenz

Saved on

compared with

New Version 4

changes.mady.by.user Ali Naseri

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Scroll Only (inline)
Online version of this manual and other related documents can be found at https://wiki.trenz-electronic.de/display/PD/TE0703
The Trenz Electronic Electronics TE0703 Carrier Board is a base-board for 4x5 SoMs, which exposes the MIO- and the PS/PL-pins of the SoM to accessible connectors and provides a whole range of on-board-componentes components to test and evaluate Trenz Electronix Electronics 4x5 SoMs.

See page "4 x 5 cm carriers" to get information about the SoMs supported by the TE0703 Carrier Board.

...

TE0703 has on-board USB 2.0 High Speed UART/FIFO FT2232HQ from FTDI. Channel A can only be used in simple UART mode, Channel B can be used as UART, in 245 FIFO FIFO, JTAG (MPSSE) or High Speed Serial modes. An standard 256 Byte EEPROM to store custom Configuration settings for FT2232H is available. EEPROM settings can be changed using FTDI provided tools that can be downloaded from FTDI website. See FTDI website for more information.

...

On-board ethernet jack J14 pins are routed to B2B connector JB1. Ethernet jack J14 LED's are all routed to CPLD Bank 1. !!! (citation needed, what is going on inside the CPLD with LED signals).

USB Interface

TE0703 board has two physical USB sockets:

...