...
Scroll Title |
---|
title | 4x5 Module Controller IOs |
---|
|
Scroll Table Layout |
---|
orientation | landscape |
---|
sortDirection | ASC |
---|
repeatTableHeaders | default |
---|
sortByColumn | 1 |
---|
sortEnabled | false |
---|
cellHighlighting | true |
---|
|
Name | Module B2B Pin | Carrier B2B Pin | Direction (Module view) | Description | Recommendation |
---|
JTAGSEL | JM1-89 | JB1-90 | in | JTAG Chain multiplexer. Low FPGA, High CPLD. For module with CPLD only. | Connect Pulldown on carrier. DIP switch possible. | SC_EN1 | JM1-28 | JB1-27 | in | Module power. Set high to enable module power. Note: Power management depends on module. Sometimes this is a only used as Power ON Reset like SC_nRST | Connect Pullup on carrier. DIP switch possible | SC_NOSEQ | JM1-7 | JB1-8 | in / inout | Module Power management. Set high to disable CPLD power management. Note: Power management depends on module and not all modules support extended power management with CPLD. | Connect Pullup or force to GND over zero ohm resistor on carrier. DIP switch possible. | SC_PGOOD | JM1-30 | JB1-29 | out / inout | Power Good signal. Is Low, if SC_EN1 is set to zero or if power is not ready, otherwise high impedance output. Note: Power management depends on module. On newer Firmware SC_PGOOD will be used as Additionally Boot Mode Pin. | Connect Pullup on carrier. Do not use this signal to enable FPGA Bank voltages. It's only for monitoring. To Enable FPGA Banks, use 3.3V(PWR_M1) or 1.8V(PWR_M2) module output. | SC_BOOTMODE | JM1-32 | JB1-31 | in | Boot Mode selection Pin for Zynq module only. Default low for primary SD boot and high for primary QSPI boot. Note: Depends also on module CPLD firmware | Connect Pullup on carrier. DIP switch possible. | SC_nRST | JM2-18 | JB2-17 | in | Low active module reset. Pin force Power one reset on FPGA/SoC. Note: Depending from module CPLD or voltage supervisor is used. | Connect Pullup on carrier. DIP switch possible. |
- Controller IOs are 3.3V IOs
|
Remove 4x5 module
Widget Connector |
---|
url | https://www.youtube.com/watch?v=uisv2dWbktc |
---|
|
...
4 x 5 SoMs Handling and Usage Precautions
Compatibility Guide
Ethernet LED'S
...