Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Migrated to Confluence 5.3

Organized by modules

TE0300 features the following slide switches:

...

Organized by types

EEPROM switch (aka FX2 Firmware Configuration selection)

EEPROM enabled: a connection between EEPROM and USB FX2 microcontroller exists.

...

Tip

EEPROM switch is ON by default, to allow the USB FX2 microcontroller to read the serial EEPROM and enumerate as a custom/specific USB device.

Power Rails Configuration

Power Rails Configuration:

Master Reset

Master Reset (aka Reset Line):

  • TE0300: S2
  • TE0320: S1D
  • TE0630: it doesn't exist as a switch but only as a button.

FPGA Configuration selection

FPGA Configuration selection (SPI+Jtag or only JTAGMode Pins):

  • TE0300: S4
  • TE0320: it doesn't exist as a switch
  • TE0630: it doesn't two mode selection pin are hardwired (they do not exist as switches), only one exist as a switch

FPGA Configuration selection (Mode Pins):

  • TE0300: they do not exist as switches: S4 (SPI+Jtag or only JTAG).
  • TE0320: S1[B:C], more information here.
  • TE0630: all mode selection pins are hardwired (they do not exist as switches).