To configure a TE USB FX2 module via USB bus, there are different procedures to follow according to module status and purpose of use.
See OpenFutNet, Firmware Tool Comparison ane .Tools Comparison,
For instance, a full quality control test already performed at Trenz Electronic laboratory premises requires all the following steps to be performed:
- Cypress USB generic device driver installation;
- USB FX2 microcontroller large EEPROM programming;
- specific USB device driverinstallation;
an *.iic file generation/download;
a firmware upgrade tool (Cypress tools: CyConsole or CyControlCenter TE tools: OpenFut, OpenFutNet or FX2EEPROMProgrammer) utilization.
reference
...
bitstream file written on SPI Flash
...
| Scroll pdf title |
|---|
| title | Configuration steps via USB bus according to module status and purpose of use. |
|---|
|
step | first
development
cycle | following
development
cycles | EEPROM recovery
(boot recovery) | quality
control
(lab test) |
|---|
(1) | | |
|
...
...
| (2) | | |
|
...
...
| (3) |
|
...
...
| (4) |
|
...
...
...
| (5) |
|
...
...
...
| | (6) |
|
...
...
...
| | (7) | |
|
...
...
(7) custom bitstream file written on SPI Flash is obviously not performed during quality control. |
...