...
- Select the part name corresponding to the SPI flash present on the module (STMicroelectronics M25P32, a 32 Mbit (4M x 8) Serial Flash memory).
Image Added
- iMPACT should now look like this.
Image Added
- Right click the SPI PROM device and select the "Program" operation.
Image Added
- In the "Programming Properties" window, just leave the default settings and press the "OK" button.
- iMPACT will first erase the memory (notice the mismatch between the two progress indicators)
- and then write it (notice the match between the two progress indicators).
- After successful programming, you should read the message "Program Succeeded" popping up for a few seconds in the "Direct SPI Configuration" panel.
- Switch S2 back to the "Run" position. In case you uploaded the test design, you should see the on-board led blinking at 0.5 Hz.
...
{"serverDuration": 36, "requestCorrelationId": "3d0eea231a90ed3e"}