...
- Right click the SPI PROM device and select the "Program" operation.
- In the "Programming Properties" window, just leave the default settings and press the "OK" button.
Image Added
- iMPACT will first erase the memory (notice the mismatch between the two progress indicators)
Image Added
- and then write it (notice the match between the two progress indicators).
Image Added
- After successful programming, you should read the message "Program Succeeded" popping up for a few seconds in the "Direct SPI Configuration" panel.
Image Added
- Switch S2 back to the "Run" position. In case you uploaded the test design, you should see the on-board led blinking at 0.5 Hz.
...
{"serverDuration": 38, "requestCorrelationId": "c4b4102b4aee4cc8"}