Versions Compared

Old Version 4

changes.mady.by.user Sergio Pavesi

Saved on

compared with

New Version 5

changes.mady.by.user Sergio Pavesi

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Note
Please note that the power consumption of the FPGA is highly dependent on the design actually loaded. So please use a tool like Xilinx Xpower to estimate the expected power consumption of your design.
Note

Even if the provided voltages of the module are not used on the carrier board, it is recommended to bypass them to ground with 10 nF - 100 nF capacitors.

Supply from B2B Connector

 The B2B connector power supply requires a single nominal 5 V DC power supply. The power is usually supplied to the module through the 5 V contacts (5Vb2b) of B2B connector J5 (see chapter J5 Pin-out). The recommended minimum supply voltage is 4 V. The maximum supply voltage is 5.5 V. The recommended maximum continuous supply current is 1.5 A.

FPGA I/O banks power supply

...