Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Host Computer's Software Connection (with I2C EEPROM) Available

These two commands could (not should) be used to change FX2 microcontroller's firmware and readback the EEPROM content.

Note
The EEPROM switch should be enabled, or these two command will fail.

Host Computer's Software Connection (with I2C FPGA or other device) Available

Reference Design (Logic Architecture Layer = Reference Architecture Layer)

The I2C bus is used to deliver MicroBlaze API Commands (MB Commands) to FPGA's MicroBlaze through FPGA's XPS_I2C_SLAVE custom IP block. The I2C bus is also used to retrieve the status of the MicroBlaze (SET_INTERRUPT commandFX22MB_REG0_GETVERSION commandGET_INTERRUPT command). See  Reference Architecture Layer.

Reference Architecture Layer


General Description

TE USB FX2 module has a flexible IIC (aka I2C) bus on-board as outlined in the figure below.

...