Page History

...

1. Power on TBE0707 (5V)
   
   1. check current: ~1.0A

   2. check shortly after start Done LED goes of

      TE0720	TE0820
      green LED D4	red LED D1

   3. 3 red LEDs on TEB0707 go off after Linux startup. This indicates system ready for test.
2. Power on CR00140 motor stage (24V)
   1. check current ~0.05A
3. Press push button S1 on CR00140 (D1 on CR00140 should now blink)
   The setup should look like this, (+cooler on Module)
   
4. Open saved Matlab project from above.
5. t6_download Bitstream (module will automatically restart, no vivado HW manger should be connected, otherwise restart will fail.)
   

   draw.io Diagram
   border truefalse diagramName CR00140_Mathworks_run_bit simpleViewer false width links auto tbstyle top diagramDisplayName lbox truefalse diagramWidth 899 revision 1

   
   

   1. Current consumption

      TE0720	TE0820
      ~0.8 A	~1.2 A

   2. three red LEDs D4, D5, D6 on TEB0707 go off after peatlinux is up completely. (Can also be checked via UART console, e.g. use putty, Baut rate 115200)
6. open t7_openZynqARMmodel
   1. If Scope window doesen't open automatically, double click on Scope
   2. Press Run
   3. Wait until motor demo has finished (1 minute +)
      

      draw.io Diagram
      border truefalse diagramName CR00140_test_mathworks simpleViewer false width 600 links auto tbstyle top diagramDisplayName lbox truefalse diagramWidth 1220 revision 1