Page History
...
- 6-pin header J26 for selecting Bank34 VCCIO voltage
- 6-pin header J27 for selecting XMOD/JTAG reference voltage
- Samtec Razor Beam™ LSHM-150 B2B connector JM1
- Samtec Razor Beam™ LSHM-150 B 2B connector JM2
- JTAG/UART header JX1 ('XMOD FTDI JTAG Adapter' compatible pin-assignment)
- Ultra small SMT coaxial connector J5
- Ultra small SMT coaxial connector J6
- Ultra small SMT coaxial connector J7
- Ultra small SMT coaxial connector J8
- User LED D1 (green)
- User LED D2 (red)
- LED D3 (red) indicating 'Programming DONE'-signal from module's FPGA
- SFP+ Connector J1
- 10-pin header soldering-pads J4 for access to SoM's IO-banks (LVDS-pairs possible, VCCIO voltages: 3.3V, 3.3V_OUT from module)
- 16-pin header soldering-pads J3, JTAG/UART header ('XMOD FTDI JTAG Adapter' compatible pin-assignment) with 2 additional pins for reference-clock input to 4 x 5 cm SoM
- 50-pin header soldering-pads J20 for access to SoM's IO-banks (LVDS-pairs possible, VCCIO voltages: 3.3V, Bank34 VCCIO voltage)
- 50-pin header soldering-pads J17 for access to SoM's IO-banks (LVDS-pairs possible, VCCIO voltages: 3.3V, V_CFG from module)
...
| SFP+ pin | SFP+ pin netname | B2B | Note |
|---|---|---|---|
| Transmit Data + (pin 18) | MGT_TX3_P | JB2-26 | - |
| Transmit Data - (pin 19) | MGT_TX3_N | JB2-28 | - |
| Receive Data + (pin 13) | MGT_RX3_P | JB2-25 | - |
| Receive Data - (pin 12) | MGT_RX3_N | JB2-27 | - |
| Receive Fault (pin 2) | MIO10 | JB1-96 | - |
| Receive disable (pin 3) | not connected | - | - |
| MOD-DEF2 (pin 4) | MIO13 | JB1-98 | 3.3V pull-up, (usuable usable as SDA, I²C-MasterSDA) |
| MOD-DEF1 (pin 5) | MIO12 | JB1-100 | 3.3V pull-up, (usuable usable as SCL, I²C-MasterSCL) |
| MOD-DEF0 (pin 6) | MIO11 | JB1-94 | - |
| RS0 (pin 7) | not connected | - | - |
| LOS (pin 8) | MIO0 | JB1-88 | - |
| RS1 (pin 9) | not connected | - | - |
...
Overview
Content Tools