...

Internal

Temperature Sensor

Onboard a Maxim 1-Wire Temperature sensor DS18S20Z+ is available, which is located on the potential of the FPGA board as close as possible to the central motor MOSFETs.
Addional 1-Wire temperature sensor can be connected by wire to connector J16:

• Pin 1(DQ), 3 (GND),5 (+3.3V) at the same 1-wire bus as the onboard one
• Pin 2(DQ), 4 (GND),6 (+3.3V) at a separate 1-wire bus

Power and Power-On Sequence

...

1. Disconnecting the reference motor board TEC0060 by unmounting its screws and the encoder cable from J10
2. mounting the deliverd 30A Fuse to the connectors J5 and J6 with the deliverd M5 screws
3. Connecting with a cable lugs the +DC 5..48V to J6 and the corresponding GND to J1.
   1. The cable length is limited to 3m.
4. Connection the three motor phases to J2 (A), J3 (B) and J4 (C).
   1. The cable length is limited to 3m.
5. Optional: connect the encoder wires to J10 or J11
   and set jumper field according to signal specification: differential or single ended
   See section TODO for details

Power Consumption

Power-On Sequence

Any power sequence of the three supply sources is allowed:

...