Page History

...

Refer to https://shopwiki.trenz-electronic.de/dedisplay/Download/?path=Trenz_Electronic/TE0726PD/TE0726+TRM for downloadableonline version of this manual and additional technical documentation of the product.

...

• Xilinx Zynq XC7Z010-1CLG225C
  - REV3: DDR3L SDRAM (512 MByte)
  - REV2: DDR3L SDRAM (128 - 512 MByte)
  - REV1: LPDDR2 SDRAM (64 MByte)
• 16 MByte Flash
• Raspberry Pi Model 2 form factor
• LAN9514 USB hub with 10/100 Ethernet
  - 4 x USB 2.0 with power switches
  - 10/100 Mbit Ethernet RJ45
• Micro SD card slot with card-detect switch
• HDMI connector
• DSI connector (Display)
• CSI-2 connector (Camera)
• HAT header with 26 I/Os
• Micro-USB
  - power input
  - USB UART
  - JTAG ARM- and FPGA-Debug
• 3.5 mm stereo audio socket (PWM audio output only)

  Page break

Block Diagram

Main Components

1. Xilinx Zynq XC7Z010 All Programmable SoC, U1
2. 512 MByte DDR3L SDRAM, U8
3. Lattice Semiconductor MachXO2 System Controller CPLD, U11
4. Dual high-speed USB to multipurpose UART/FIFO, U3
5. 2 Kbit Microwire compatible serial EEPROM, U6
6. Low-power, programmable oscillator @ 12.000000 MHz, U7
7. Ultra-low capacitance double rail-to-rail ESD protection diode ,U4
8. Micro-USB 2.0 B receptacle, J1
9. Green LED (GLED), D1
10. Red LED (RLED), D2
11. DSI LCD connector, J4
12. JTAGENB, when low, TDO, TDI, TMS and TCK function as GPIOs, J15
13. Fiducial mark PM2
14. External I²C bus with interrupt signal and power line, J2
15. Low-voltage 4-channel I²C and SMBus multiplexer with interrupt logic, U10
16. 2x20 pin 2.54 GPIO header, J8

17. 128 Mbit (16 MByte) 3.0V SPI Flash memory, U5

18. USB 2.0 Hub and 10/100 Ethernet controller, U2
19. External reset
20. 2 Kbit Microwire compatible serial EEPROM, U9
21. PUDC of Zynq, active low enables  internal pull-ups during configuration on all SelectIO pins
22. Dual USB A receptacle, J12. Also fiducial mark PM1
23. Dual USB A receptacle, J11
24. Low power programmable oscillator @ 25.000000 MHz, U13
25. Molex’s miniature traceability S/N pad for low-cost, unique product identification
26. RJ-45 Ethernet connector with 10/100 integrated magnetics, J10. Also fiducial mark PM3
27. 3.5mm RCA audio jack, J7
28. 1A PowerSoC synchronous buck regulator with integrated inductor (3.3V), U20
29. 1A PowerSoC synchronous buck regulator with integrated inductor (1.8V), U19
30. ZIF FFC/FPC CSI-2 camera connector, J3
31. HDMI connector, J6

32. Common mode filter with ESD protection, D8

33. Common mode filter with ESD protection, D9

34. 1A PowerSoC synchronous buck regulator with integrated inductor (1.35V), U16
35. Additional external +5V power supply connector, J5

36. Highly integrated full featured hi-speed USB 2.0 ULPI transceiver, U18

37. Low-power programmable oscillator @ 33.333333 MHz, U14
38. Ultra-low supply current voltage monitor with optional watchdog, U22
39. Fiducial mark PM4
40. Micro SD memory card connector with detect switch, J9
41. JTAG interface, TP1 (TDI), TP3 (TDO), TP5 (TCK), TP7 (TMS)
42. 1A PowerSoC synchronous buck regulator with integrated inductor (1.0V), U17
43. Fiducial mark PM6
44. 0.5A dual channel current-limited power switch, U15
45. 0.5A dual channel current-limited power switch, U21
46. Fiducial mark PM5

...

...