Page History

...

...

1. _create_win_setup.cmd/_create_linux_setup.sh and follow instructions on shell:
   
2. Press 0 and enter for minimum setup
3. (optional Win OS) Generate Virtual Drive or use short directory  for the reference design (for example x:\<design name>)
4. Create Project
   
   1. Select correct device and Xilinx install path on "design_basic_settings.cmd" and create Vivado project with "vivado_create_project_guimode.cmd"
      Note: Select correct one, see TE Board Part Files
5. Create HDF and export to prebuilt folder
   
   1. Run on Vivado TCL: TE::hw_build_design -export_prebuilt
      Note: Script generate design and export files into \prebuilt\hardware\<short dir>. Use GUI is the same, except file export to prebuilt folder
6. Create Linux (uboot.elf and image.ub) with exported HDF
   
   1. HDF is exported to "prebuilt\hardware\<short name>"
      Note: HW Export from Vivado GUI create another path as default workspace.
   2. Create Linux images on VM, see PetaLinux KICKstart
      1. Use TE Template from /os/petalinux
      2. For 128MB and 64MB only:Netboot Offset must be reduced manually, see Config 68616202
7. Add Linux files (uboot.elf and image.ub) to prebuilt folder
   
   1. "prebuilt\os\petalinux\default" or "prebuilt\os\petalinux\<short name>"
      Notes: Scripts select "prebuilt\os\petalinux\<short name>", if exist, otherwise "prebuilt\os\petalinux\default"
8. Generate Programming Files with HSI/SDK
   
   1. Run on Vivado TCL: TE::sw_run_hsi
      Note: Scripts generate applications and bootable files, which are defined in "sw_lib\apps_list.csv"
   2. (alternative) Start SDK with Vivado GUI or start with TE Scripts on Vivado TCL: TE::sw_run_sdk
      Note: See SDK Projects

...

1. Prepare HW like described in section Programming 68616202
2. Connect UART USB (most cases same as JTAG)
3. Insert SD Card with image.ub
4. Power On PCB
   Note: 1. Zynq Boot ROM loads FSBL from QSPI into OCM, 2. FSBL loads U-boot from QSPI into DDR, 3. U-boot load Linux from SD into DDR

...

...