Versions Compared

Old Version 26

changes.mady.by.user Pedram Babakhani

Saved on

compared with

New Version 27

changes.mady.by.user Pedram Babakhani

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

JTAG and UART connections are available through XMOD JTAG adapter. For more information refer to TE0790.

The DIP-switch S2 is to set different modes of powering the on-board components, the I/O voltages and to enable programming the adapter board CPLD by JTAG interface:

Scroll Title
anchorTable_XMOD_UARTJTAG
titleUARTXMOD JTAG DIP Switch

Scroll Table Layout
orientationportrait
sortDirectionASC
repeatTableHeadersdefault
style
widths
sortByColumn1
sortEnabledfalse
cellHighlightingtrue

DIP SwitchONOFFDefaultDescription
1Normal modeAdapter board CPLD update modeONUpdate Mode JTAG access to SC CPLD only
2Do not use (illegal setting)Normal modeOFFMust be in OFF state always.
3VIO connected to 3.3VPower VIO from pin header J2OFFUser I/O Voltage
4Power 3.3V from USBPower 3.3V from pin header J2OFFPower on-board peripherals (FTDI chip & SC CPLD, ...)


DIP Switch on the XMOD JTAG adapter must be set  like the following table.

Receive
Scroll Title
anchorTable_XMOD_JTAG
titleXMOD JTAG DIP Switch

Scroll Table Layout
orientationportrait
sortDirectionASC
repeatTableHeadersdefault
style
widths
sortByColumn1
sortEnabledfalse
cellHighlightingtrue

DIP SwitchSetting
1ON
2OFF
3OFF
4ON
Designator

Connected to

B2B Pin

XMOD Header JB1DirectionNote
UART TxdMIO52J2-15JB1-3InputTransfer
UART Rxd MIO53J2-16JB1-7Output


Reference Designs

Page properties
hiddentrue
idComments

In this Section you must refer to the Reference Design (Test board) for the particular module.

For Example: TE0728 Reference Designs

...