Versions Compared

Old Version 9

changes.mady.by.user Martin Rohrmüller

Saved on

compared with

New Version 10

changes.mady.by.user Martin Rohrmüller

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Warning

Check the TRM of the attached 4x5 Module for the correct Battery voltage. Do not short or swap polarity, this may damage the module!

Pinheader J19 is, if available, for PJTAG access or can be used as connector for the 4 IO pins.

Scroll Title
anchorTable_OBP_Jumper
titleJumper positions

Scroll Table Layout
orientationportrait
sortDirectionASC
repeatTableHeadersdefault
style
widths
sortByColumn1
sortEnabledfalse
cellHighlightingtrue

PinSignal Schematic NameConnected to, pinNOTE
13V3IN-Instant on Power rail.
2PJTAG_TMSJB1-98Check 4x5 module TRM for capability of connected IO
3GND--
4PJTAG_TCKJB1, 96Check 4x5 module TRM for capability of connected IO
5GND--
6PJTAG_TDOJB1, 100Check 4x5 module TRM for capability of connected IO
7---
8PJTAG_TDIJB1, 94Check 4x5 module TRM for capability of connected IO
9GND--
10---



Warning

The 3V3IN power rail connected to pin 1 is instant on. Do not use for IO enable.

On-board LEDs

There are 4 green LEDs on the board, two of them are for user purpurses and controlabe via the RGPIO of the actual delivery firmware.

...