Page History

...

1. 4x5 module connectors
2. Jumper J4 (VCCIOA)
3. Jumper J7 (VCCA_SD)
4. Dip swiches S2 and S3
5. 6-pin PCI-E ATX Power Connector
6. micro USB  connector for FTDI USB to JTAG/UART bridge
7. Push button
8. Power LED
9. Status LED
10. top load microSD card cage

...

1. Select Voltage VCCA_SD of 4x5 module bank where SD-Card is connected by Jumper J7 (1-2 →3.3V; 2-3 1.8V). Compare TRM of actually used 4x5 module.
2. Select VCCIOA Voltage by setting J4 (1-2 →3.3V; 2-3 1.8V). If both FFA and FFB are not used any setting is ok. Do not leave open (communication of 4x5 module with TEF1002 CPLD is only possible with availabe VCCIOA)!Select dip switch settings according to the attached 4x5 module and your needs:

3. 
   

   Dip	Setting	Note
   S1		Push button configured as reset
   S2-1	OFF	FMC _VADJ OFF. The choice OFF, ON, OFF selects 1.8V FMC_VADJ, wich is a valid bank power for TE0720.
   S1S2-2	OFF
   S1S2-3	OFF
   S1S2-4	ON	Selects 4x5 module SOC/FPGA JTAG
   S1S2-5	ON
   S1S2-6	OFF
   S1S2-7	ON	Module  power enable.
   S1S2-8	ON	Use extended power sequenzing.
   S2S3-1	OFF/ON	For Zynq modules: Primary Boot Mode SD/QSPI.
   S2S3-2	OFF	ON for TE0720 (overide automatic enable FMC__VADJ). For TE0720 bank bank 34 has to be powerded to start up. Therefore FMC VADJ has to be set to a valid value e.g. 1.8V

   
   

4. Connect 12V ATX connector
5. Connect mico USB J10 to PC
6. Use Xilinx JTAG tools to programm FPGA or  for Zynq modules use micro SD Card.
7. Use e.g. Putty on PC to check for UART interactions.

...

Select dip switch settings according to the attached 4x5 module and your needs

There is a switch (S??) which is connected to RESET signal, it resets the system entirely.

...

Jumpers

...

JTAG and UART connections are available through mini USB connector.

JTAG(first FTDI port) and UART(second FTDI port) is over MicroUSB connector possible. External JTAG Programmer is not needed.

...