You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 4 Next »

Table of Contents

TEF1002

Overview

Board Overview
  1. 4x5 module connectors
  2. Jumper J4 (VCCIOA)
  3. Jumper J7 (VCCA_SD)
  4. Dip swiches S2 and S3
  5. 6-pin PCI-E ATX Power Connector
  6. micro USB  connector for FTDI USB to JTAG/UART bridge
  7. Push button
  8. Power LED
  9. Status LED
  10. top load microSD card cage



  1. Select Voltage VCCA_SD of 4x5 module bank where SD-Card is connected by Jumper J7 (1-2 →3.3V; 2-3 1.8V). Compare TRM of actually used 4x5 module.
  2. Select VCCIOA Voltage by setting J4 (1-2 →3.3V; 2-3 1.8V). If both FFA and FFB are not used any setting is ok. Do not leave open (communication of 4x5 module with TEF1002 CPLD is only possible with availabe VCCIOA)!
  3. DipSettingNote
    S1
    		Push button configured as reset

    S2-1

    		OFF

    FMC _VADJ OFF. The choice OFF, ON, OFF selects 1.8V FMC_VADJ, wich is a valid bank power for TE0720.


    S2-2OFF
    S2-3OFF
    S2-4ONSelects 4x5 module SOC/FPGA JTAG
    S2-5ON
    S2-6OFF
    S2-7ONModule  power enable.
    S2-8ONUse extended power sequenzing.
    S3-1OFF/ONFor Zynq modules: Primary Boot Mode SD/QSPI.
    S3-2OFFON for TE0720 (overide automatic enable FMC__VADJ). For TE0720 bank bank 34 has to be powerded to start up. Therefore FMC VADJ has to be set to a valid value e.g. 1.8V 
  4. Connect 12V ATX connector
  5. Connect mico USB J10 to PC
  6. Use Xilinx JTAG tools to programm FPGA or  for Zynq modules use micro SD Card.
  7. Use e.g. Putty on PC to check for UART interactions.


Power supply

Single 12V power supply with minimum current capability of 3A is recommended to power on the board. 

DIP-Switches and Push Buttons

Select dip switch settings according to the attached 4x5 module and your needs

There is a switch (S??) which is connected to RESET signal, it resets the system entirely.

Signal

DesignatorB2BActive Level





DIP Switches /Push Buttons


Jumpers

DesignatorConnected toB2BNote

Boot_R
Open:
Short:
Jumpers

LEDs

There are three user LEDs which can be used for variant purposes.

DesignatorColorConnected toB2BActive LevelNote


















Carrier LEDs

DesignatorColorConnected toActive LevelNote










Module LEDs

DesignatorColorConnected toActive LevelNote










Carrier LEDs

JTAG/UART

JTAG and UART connections are available through mini USB connector.

JTAG(first FTDI port) and UART(second FTDI port) is over MicroUSB connector possible. External JTAG Programmer is not needed.

Designator

Connected to

B2B Pin

XMOD Header JB?DirectionNote












UART

Reference Designs

Notes


  • No labels