Table of Contents
Overview
Module Overview
Power supply
Single 5V power supply with minimum current capability of 2.5A is recommended to operate the board.
DIP-Switches and Push Buttons
There is a switch S1 which is connected to RESET signal which resets the system entirely.
Signal | Designator | B2B | Active Level |
|---|---|---|---|
RESET | S1 | J2-7 | Active High |
DIP Switchs and Push Buttons
There are no DIPs on TE0728. In case of TE0790 (XMOD) usage, see power supply section.
LEDs
There are three user LEDs which can be used for variant purposes.
| Designator | Color | Connected to | B2B | Active Level | Note |
|---|---|---|---|---|---|
| D1-A | Red | MIO48 | J2-30 | Active high | |
| D1-B | Yellow | MIO49 | J2-38 | Active high | |
| D1-C | Green | MIO50 | J2-36 | Active high |
On-board LEDs
JTAG/UART
JTAG and UART is possible over miro USB connector.
miroUSB UART is connected to PL IO (RX: Pin H13, TX: Pin H14).
Reference Designs
Notes
Overview
Content Tools