You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 11 Next »

Table of Contents

Overview

Module Overview


Power supply

Single 5V power supply with minimum current capability of 2.5A is recommended to operate the board.

DIP-Switches and Push Buttons

There is a switch S1 which is connected to RESET signal which resets the system entirely.

Signal

DesignatorB2BActive Level

RESET

S1

J2-7

Active High
DIP Switchs and Push Buttons

There are no DIPs on TE0728. In case of TE0790 (XMOD) usage, see power supply section.

Jumpers

DesignatorConnected toB2BNote
J4Boot_RJ2-11Open: QSPI
Short: SD Card
On-board Jumpers

LEDs

There are three user LEDs which can be used for variant purposes.

DesignatorColorConnected toB2BActive LevelNote
D1-ARedMIO48J2-30Active high
D1-BYellowMIO49J2-38Active high
D1-CGreenMIO50J2-36Active high
On-board LEDs

JTAG/UART

JTAG and UART is possible over miro USB connector.

miroUSB UART is connected to PL IO (RX: Pin H13, TX: Pin H14).

Reference Designs

Notes

  • No labels