TEBF0808 Getting Started

TEBF0808 with TE080x

Overview

1. Reset Button S2
2. LEDs D7 Red (Usage: status) and D6 Green (Usage: status)
3. Reset Button S1
4. Power Jack 2.1mm (optional 12V power input)
5. S5 DIP for Boot Mode and FMCVADJ
6. Enclosure Pin header(Reset and Power Button, HD LED (Usage: status/user) and Power LED (Usage: status/user))
7. S4 DIP for CPLD access and power control
8. XMOD J12 with green dot for Module JTAG and UART, XMOD LED D4 Red used  for status information
9. XMOD J28 for CPLD,FMC JTAG and Firmware ID over UART(need CPLD Firmware 7 or newer) , XMOD LED D4 Red used for status information
10. FPGA Done LED (location varies slightly depending on module)
11. ATX Power Connector (Main 12V and 5V Power supply), recommended power supply connector
12. SFP LED D1 Red
13. SFP LED D8 Green
14. SFP LED D9 Red
15. SFP LED D10 Green
16. ETH LED Yellow
17. ETH LED Green/Orange
18. LEDs D4 Green (Usage: status/user) and D5 Red (Usage: status/user)

Power supply

DIP-Switches and Push Buttons

Jumpers

LEDs

Furthermore, there are two user LEDs on module TE0728.

JTAG/UART

SoC JTAG and UART connections are available through XMOD JTAG adapter with the green dot on J12. For more information refer to TE0790.

DIP Switch on the XMOD JTAG adapter must be set like the following table.

Reference Designs

• TE0803 Reference Designs
• TE0807 Reference Designs
• TE0808 Reference Designs

Notes

Module and Carrier are also as starter kit available:

• Starter Kit 803
• Starter Kit 808