TE0790 will be delivered in 2 different Variant, which differs only in FTDI EEPROM configuration for FT2232H FTDI device.
*xx means PCB Revision
Programmer Power supply setting depends on connected carrier on J2 Pinheader. To check Programmer without connected FPGA Hardware set following dip settings before connecting USB
| S2 DIP | Position | Description |
|---|---|---|
| 1 | ON | Normal mode |
| 2 | OFF | Must be in OFF state always. |
| 3 | OFF | Power VIO from pin header J2(CPLD Bank voltage) |
| 4 | ON | Power 3.3V from USB (Use USB supply stand alone or in case TE0790 J2-5 Pin is not supplied by carrier) |
For more details see: TE0790 TRM
TE0790 with green dot sticker are factory programmed with AMD/Digilent Licence or AMD Trenz License.
| TE0790-xx | TE0790-xx-L |
|---|---|
Reliability of identification: Uncertain, in case sticker was removed.
FT2232H on TE0790 has two configurable ports which are default show as COM port.
TE0790 with AMD/Digilent or AMD/Trenz Licence shows normally only one COM Port TE0790 without Licence key two ports are shown.
| TE0790-xx | TE0790-xx-L |
|---|---|
Reliability of identification: Uncertain, in case FTDI was reprogrammed manually for one COM Port only or driver ignore FTDI configuration.
Part of the EEPROM content is visible with Microsoft USB viewer.
USB viewer is available on: https://ftdichip.com/utilities/
| TE0790-xx | TE0790-xx-L |
|---|---|
Product is identified as "Digilent USB Device" or "Trenz USB Device" Product Serial Number starts with "251633...." or "TE..." | Product is identified as "Dual RS232-HS" Product Serial Number is with "0x00" |
Reliability of identification: Mostly certain
TE0790 with Digilent/AMD Licence shows normally only one COM Port TE0790 without Licence key show two ports.
| TE0790-xx | TE0790-xx-L |
|---|---|
| |
Programmer is shown as Digilent device with serial "251633...." or Xilinx device with serial "TE..." | Programmer is not detected inside Vivado |
Reliability of identification: Certain
Note: Custom FTDI Programming with Vivado 2022.2 and newer is possible, see: AMD FTDI JTAG Programmer
6 digit serial number of the module is located on the bottom side of the programmer, on the small sticker with QR Code.
Write Email to support@trenz-electronic.de and serial number will be checked from our support team.
Reliability of identification: Certain