...
Scroll pdf title | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
...
(3) Firmware Recovery:requires USB generic Cypress device driver, to boot with EEPROM disabled and to enable EEPROM after TE USB FX2 module is inserted into USB port. This is the procedure followed by Recovery Boot by implicit two step recovery boot (TE USB FX2 Firmware Recovery) (CyConsole and CyControl) and Recovery Boot and implicit two step recovery boot (OpenFutNet).
(4) You can use Recovery Boot The user can use implicit two step recovery boot to program the USB FX2 microcontroller's EEPROM with the Generation 3 Firmware required by Firmware Update and FPGA Configuration.
...
(8) To write a new firmware in FX2 microcontroller's RAM, fx2loader does not require a reference firmware but, to write a new firmware in FX2 microcontroller's EEPROM a firmware supporting EEPROM writing should already run be runnning in FX2 microcontroller's RAM.
(9) To write a new firmware in FX2 microcontroller's RAM, fxload does not require a reference firmware but, to write a new firmware in FX2 microcontroller's EEPROM a firmware supporting EEPROM writing should already run be running in FX2 microcontroller's RAM (Vend_Ax.hex is normally used).
...