Page History
...
With this configuration, I²C device with address 0x20 should be visible on I²C bus
...
This device is an emulation of TCA6416 I²C GPIO Chip. GPIO input and output pins are used to get status and control the system.
| Address | Register | Description |
|---|---|---|
| 0 | Input Port 0 | Power status register: Bit 0 - LP_PGOOD Bit 1 - PG_PL Bit 2 - PG_PSGT Bit 3 - PG_GT_L Bit 4 - PG_GT_R Bit 5 - PG_DDR Bit 6 - Not Used "0" Bit 7 - Not Used "0" |
| 1 | Input Port 1 | FAN Status register Bits 7:0 - FAN RPM/1000 (Nominal Sepa HFB44B-12A speed is 8000 RPM) |
| 2 | Output Port 0 | Control register 0 Bits 1:0 - LED Control (Default "01") Bit 2 - SMB Strong Pull-Up Enable (Default "1") Bit 3 - Enable DAC1 Power (Default "1") Bit 4 - Enable DAC2 Power (Default "1") Bit 5 - Enable DAC3 Power (Default "1") Bit 6 - Enable DAC4 Power (Default "1") Bit 7 - Enable FPD Power (Default "1") |
| 3 | Output Port 1 | Control register 1 Bit 0 - Enable LPD Power (Default "1") Bit 1 - Enable DDR Power (Default "1") Bit 2 - Enable PSGT Power (Default "1") Bit 3 - Enable GT_L Power (Default "1") Bit 4 - Enable GT_R Power (Default "1") Bit 5 - Enable FAN Power (Default "1") (Works only if 4-wire FAN is used) Bit 6 - Not used Bit 7 - Not used |
I²C GPIO registers can be operated with directly, using Linux i2cset and i2cget commands
...
Overview
Content Tools