Versions Compared

Old Version 12

changes.mady.by.user Sergio Pavesi

Saved on

compared with

New Version Current

changes.mady.by.user Sergio Pavesi

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Migrated to Confluence 5.3

Switches: settings for USB Firmware, FPGA bitstream programming,  Power Supply  and reset.

Organized by modules

TE0300 is provided with features the following slide switches:

  • S1: 1 x slide switch (system)
  • S2: 1 x slide switch (system)
  • S3: 1 x slide switch (system)
  • S4: 1 x slide switch (system)

TE0320 is provided with features the following slide switches:

  • S1: 4 x DIP slide switches (system)
  • S2: 1 x slide switch (system)
  • S5: 8 × x DIP slide switches (user)

TE0630 is provided with features the following slide switches:

  • S1: 4 x DIP slide switches (system/user)

Organized by types

EEPROM switch (aka FX2 Firmware Configuration selection)

EEPROM enabled: a connection between EEPROM and USB FX2 microcontroller exists.

...

Tip

EEPROM switch is ON by default, to allow the USB FX2 microcontroller to read the serial EEPROM and enumerate as a custom/specific USB device.

Power Rails Configuration

Power Rails Configuration:

Master Reset

Master Reset (aka Reset Line):

  • TE0300: S2
  • TE0320: S1D
  • TE0630: it doesn't exist as a switch but only as a button.

FPGA Configuration selection

FPGA Configuration selection (SPI+Jtag or only JTAGMode Pins):

  • TE0300: S4
  • TE0320: it doesn't exist as a switch
  • TE0630: it doesn't two mode selection pin are hardwired (they do not exist as switches), only one exist as a switch

FPGA Configuration selection (Mode Pins):

  • TE0300: they doesn't exist as switches: S4 (SPI+Jtag or only JTAG).
  • TE0320: S1[B:C], for more information here.
  • TE0630: they doesn't all mode selection pins are hardwired (they do not exist as switches).